The Icom 7300 N1MM Logger should be displaying the radio frequency at the top of the window next to the icon. Go back and verify the above settings and make sure your com ports are correct. If you do, something is not setup correctly. Click OK to close the Configurer window.Mine is DTR (pin 4)=CW, RTS (pin 7)=Always Off, Radio Nr=1, PTT Delay (msec)=30, Dig Wnd Nr=1, Allow ext interrupts and Winkey go UNchecked, Two Radio Protocol=None and Footswitch (pin 6)=None. Next to that check Digi and also check CW/Other. N1MM Logger, MMTTY, EXTFSK are the software programs for RTTY (FSK) being used with the Icom 7610.The next row under Port, choose the COM port your USB cable is connected to.Footswitch (pin 6)=None and Radio Polling Rate=Normal. Mine is 9600, N, 8, 1, DTR (Pin4)=CW, RTS (pin 7)=PTT, Icom Code (hex)=94, Radio Nr=1, PTT Delay=30 and PTT via Radio Command SSB Mode is checked. Make sure your Com port is setup correctly. ![]() ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |